![]() The head of each threaded insert should be recessed into the slot provided on the backplate.įrom the back of the motherboard, align the backplate so the threaded inserts fit into each of the four holes that would secure the OEM heat sink and fan assembly.ĭo not worry about the arrangement looking symmetrical because it will appear misaligned for the 1155 socket. With the numbers on the backplate facing you, insert the threaded metal inserts into the proper holes corresponding to your socket type. Lay out the eight screws for the fans and the eight flat washers and put a flat washer on each screw. These instructions will assume this is a new system build so you cannot install the software first as the Antec instructions dictate.įor the Intel 1155 processor we used the blue inserts, wider retention ring and the wider backplate. ![]() It is our hope that you will read these instructions thoroughly before beginning installation to get a vision of what you will be doing as you install your new Antec Kuhler H2O 920. ![]() We recently installed this liquid cooling system without any difficulty and wanted to share our experience with anyone it could benefit. We turned the fans so the wiring was closest to the holes in the top of the motherboard tray. ![]() Antec H2O 920 Software Software And Drivers.
0 Comments
Leave a Reply. |